6
votes
Accepted
How can I connect public and private node through a reverse SSH tunnel?
I had same exact situation. It seems that (and I did not see this documented anywhere) when using private mode, the private node must initiate the connection. In my case it was a firewall rule ...
- 869
2
votes
What does a good P2P configuration look like for a public node?
Use ./tezos-node config update --connections=300 to fix your config file, as Tom said, those numbers should not match. Then restart tezos-node. Make sure your firewall is open, and any routers are ...
- 3,364
1
vote
Multinetwork P2P error: "Another tezos node is probably running on one of these addresses. Please choose another RPC port."
I went to ~/tezos-delphinet/config.json and edited the default listen-addr to 9733:
{ "data-dir": "/home/user/tezos-delphinet",
"p2p":
{ "bootstrap-peers":...
- 480
1
vote
How to publish the public IP address of my node to the network?
Indeed there is currently no mechanism to publish an IP different from the one you use to reach other nodes.
If you want to have your machine connected through a tunnel via a public machine, you need ...
- 338
1
vote
Test failures for tezos-p2p on FreeBSD, kern.maxfiles limit exceeded
The code uses IPv6, which must be enabled on the host, and was not in my case.
1
vote
Test failures for tezos-p2p on FreeBSD, kern.maxfiles limit exceeded
Make sure you are on most recent code checkout hash: $ git log -1 should give you the hash: 0639894412 (Feb 11 2020)
I just did a complete rebuild of the source and I do not have tezos-p2p in the ...
- 3,364
Only top scored, non community-wiki answers of a minimum length are eligible